Panasonic RRXS450E - Manual (Page 26)

VQT4J81
26
26
Switch the microphone sensitivity according
to the volume of the sound source. When the
sound source volume is loud, set the sensitivity
to “LOW”. When it is low, set the sensitivity to
“HIGH”.
• Press [STOP g/RETURN] to stop the unit.
1 Press [MENU].
2 Press +, – to select “MIC REC MENU”
and press [q OK] to enter.
3 Press +, – to select “MIC SENS.”
and press [q OK] to enter.
4 Press +, – to select “HIGH” or “LOW” and
press [q OK] to enter.
(The factory setting is “HIGH”.)
To exit the setting screen, press [F2 (CLOSE)].
When the microphone position is
“STEREO” (
➜ page 14), “ ” is
displayed for High, and “ ” for Low.
When the microphone position is “ZOOM”, “ ” is
displayed for High, and “ ” for Low.
Switching microphone sensitivity
Sound of low frequency range is reduced during
microphone recording. This is effective when
reducing noise of air conditioning equipment,
etc. while recording at a meeting, etc. (LOW CUT
FILTER)
• Press [STOP g/RETURN] to stop the unit.
1 Press [MENU].
2 Press +, – to select “MIC REC MENU”
and press [q OK] to enter.
3 Press +, – to select “LOW CUT FILTER”
and press [q OK] to enter.
4 Press +, – to select “ON” and press [q OK]
to enter.
(The factory setting is “OFF”.)
To exit the setting screen, press [F2 (CLOSE)].
“ ” is displayed.
Reducing low frequency
noise during recording
VQT4J81_RR-XS450_420-E_En.indd 26 VQT4J81_RR-XS450_420-E_En.indd 26 2012/05/29 9:35:44 2012/05/29 9:35:44