Panasonic EW1012G2 - Manual (Page 19)

37 36
DISPOSAL OF THE PRODUCT
A nickel-metal hydride battery that is recyclable powers the product you
have purchased. Please contact an authorised service centre for
information on how to recycle this battery.
WARNING:
Do not disassemble the product at any time other than when disposing of it.
Failure to observe this point may result in short circuit, fire, or injury.
For repair or maintenance (such as battery replacement), take the product
to an authorised service centre.
Removing the Ni-MH battery before disposing of the product
• Before removing the battery, be sure to completely drain the unit of power.
• Use a screwdriver to loosen the screw on the bottom of the product.
• While holding the toothbrush shaft, remove the screw then remove the
parts indicated by numbers q, w, and e in the diagram.
• Be careful not to short-circuit the negative and positive poles of the
battery.
q
w
e
Nickel-metal
hydride battery
This diagram is NOT an
explanation for repair purposes.
Please dispose of the device and the battery in accordance with national or
public regulations or environmental protection or recycling regulations.
SPECIFICATIONS
Rated voltage: 100 - 240 V AC
50 - 60 Hz
Battery: 1 Ni-MH battery (1.2 V DC; 1100 mAh)
Charging time: 15 hours
Current consumption: 2 W (when fully charged)
Brush rotating speed: approx. 31,000 strokes/min. (with no load)
Brush movement width: approx. 1.0 mm for normal mode
approx. 0.7 mm for soft mode
Operating time: approx. 50 minutes of continuous use
(with 300 g load at a room temperature of 20°C
after the battery has been fully charged.)
Dimensions: Main unit: 26 - 28 (diameter) x 169 (length) mm
Charger: 134 (H) x 46 (W) x 102 (D) mm
Weight: Main unit: 150 g
Charger: 230 g
Household use
Replacement Brushes
Float brush 3-angle brush
EW0920 EW0900
(2 brush heads) (2 brush heads)
This device meets the EMC Directive 89/336/EEC and Low Voltage
Directive 73/23/EEC.
P002-P091_EW1012(欧州) 05.06.21 16:32 ページ 36