Audiovox GX2411ci - Manual (Page 14)

GX2411ci English I/B ver. 09010A-1
13 09010A-1
OWNER’S MAN #
GX2411ci
VER. 09010A-1
PAGE:
13
English version
1. Remove the battery compartment cover of the handset. Connect the rechargeable
Ni-Cd battery as shown on Figure 10.
Handset
Battery
Insert the End of the
Compartment Battery Pack Wire
RED Wire
BLACK Wire
(Figure 10)
2. Insert the Ni-Cd battery into the battery compartment of the handset.
3. Slide the battery compartment cover firmly in its closed position.
INITIAL SETUP
Before you can use your cordless telephone, the handset must be charged for at least 20
hours. See charging instruction on MAXIMIZING BATTERY LIFE section of this manual.
SETTING THE DAY AND TIME OF THE BASE UNIT
NOTE: The time set is used for time stamping the recorded message(s).
1. After 20 hours, lift the handset from the base unit.
2. Press the REMO button on the handset. The GX2411CI
will prompt “You have no new message. For help, press 9.” followed by a long beep.
(Figure 11)
3. Press 2. The unit will prompt “Time is off. Enter new day.”
4. After hearing a long beep, enter the new day (Sunday = 1, Monday = 2, Tuesday = 3,
etc.). The unit will then prompt “Enter new time.”
5. After hearing a long beep, enter the new hour (01-12).
6. After two beeps, enter the new minute (00-59).
7. After two beeps, press 1 for AM, or press 2 for PM. The unit will announce the new
day and time followed by a long beep and will prompt “Please enter next command.”
8. Press the REMO button to exit the remote mode. Otherwise, the remote function will
turn off automatically if not in use for 8 seconds.
TONE / PULSE SETTING
Select the appropriate dialing service by moving the T / P
(Tone / Pulse) switch on the bottom of the base unit:
•
TONE for Tone service, or T / P
•
PULSE for Rotary service. (Figure 12)
SETTING THE HANDSET RINGER
The handset ringer must be set to ring ON position in order that to ring when receiving an
incoming call. See PROGRAMMING MODE section on page 26.
SETTING USER'S AREA CODE AND NEIGHBORING AREA CODE
In order to use callback function, the user's area code and neighboring area code must be
programmed. Neighboring area code is optional. See PROGRAMMING MODE section on