Gx2411ci, Owner’s man, English version – Audiovox GX2411ci User Manual
Page 20
GX2411ci English I/B ver. 09010A-1
19
09010A-1
OWNER’S MAN #
GX2411ci
VER. 09010A-1
PAGE:
19
English version
CHECKING THE OGM
1.
In standby mode, press the OGM PLAY button on the
base unit to hear your previously recorded OGM. (Figure 20)
2.
You can stop OGM playback anytime during playback by pressing the STOP button.
RECORDING A MEMO
Memo message(s) is recorded remotely on the handset. The maximum recording time is 2
minutes.
1.
In standby mode, press the REMO button on the handset. The GX2411CI will prompt
“You have no new message. For help, press 9.”
2.
Press MEMO REC button. The GX2411CI will
prompt “Please record
your message after the beep. To stop, press star
(*).”
3.
After hearing a long beep, begin your message. (Figure 21)
4.
Press star (*) to stop recording.
5.
Press REMO button to exit the remote mode.
Otherwise, the unit will automatically turn off if not in use for 8 seconds.
PLAYING BACK MESSAGES
If the MEMO or MSG LED indicator is on , it indicates that you have Memo or ICM
message(s). If it is blinking, it indicates that there is new message(s). The blinking counts
mean the number of new messages.
A.
PLAYING MESSAGES
In standby mode, press the MEMO or MSG PLAY button on
the base unit . The GX2411CI will announce “You have
(number) (Memo) message.” and begins playing the first
message to the end. It will announce the message number
before each message.
(Figure 22)
B. SKIPPING MESSAGES
Press the (Skip) button on the base unit during message
playback to skip forward to the next message.
C. PREVIOUS MESSAGES
Press (Previous) button once on the base unit during
message playback to skip backward one message. (Figure 23)
D. STOP MESSAGE PLAYBACK
Press the STOP button to stop message playback.
ERASING MESSAGES
A.
SELECTIVE ERASING
1.
Press the ERASE button on the base unit during message playback.
2.
The GX2411CI will announce “(Message) (Memo) (number) erased.” and then start
the next message.
NOTE: Erased messages cannot be retrieved. There is a
momentary delay after erasing messages to allow the
GX2411CI to reorganize and optimize its memory space. (Figure 24)
B.
ERASING ALL ICM AND TWO-WAY RECORDINGS
1.
In standby mode, press and hold the ERASE button for about 2 seconds.
2.
The GX2411CI will announce “Message (number) erased. You have no message.”