Alpine CDE-9873 - Manual (Page 16)

15
-EN
You can flexibly customize the unit to suit your own preferences and
usage. From the SETUP menu, Sound Customizing, Visual
Customizing, etc., can be modified.
1
Press and hold A.SEL/SETUP for at least 2 seconds
to activate the SETUP mode.
2
Turn the Rotary encoder to select the desired
SETUP menu, and then press
/ /ENT.
(e.g. Select SUBWOOFER)
DIMMER SUBWOOFER (SUBW SYS) * 1
CLOCK ADJ* 2 PLAY MODE SCROLLTYPE
TEXT SCR POWER IC DEMO DIMMER
* 1 Displayed only when SUBW is on.
* 2 Refer to “Setting Time” (page 7).
3
Turn the Rotary encoder to change the setting.
(e.g. Select SUBW ON or SUBW OFF.)
4
Press and hold A.SEL/SETUP for at least 2 seconds
to return to normal mode.
• Press /RTN to return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Subwoofer On and Off
When the subwoofer is on, perform the steps below to adjust the
subwoofer output level.
1 In the normal mode, press Rotary encoder repeatedly to
select the SUBW mode.
2 Adjust the level by turning the Rotary encoder.
Setting the Subwoofer System
Select either SYS 1 or SYS 2 for the desired subwoofer effect.
Dimmer Control
Set the DIMMER control to AUTO to decrease the illumination
brightness of the unit with the head lights of the vehicle ON. This mode
is useful if you feel the unit’s backlighting is too bright at night.
Scroll Type Setting
Choose from two scrolling methods.
Select the type you prefer.
SETUP
Use steps 1 to 4 to select one of the SETUP modes to
modify. See the applicable section below for details
about the selected SETUP item.
Rotary encoder / /ENT
/RTN A.SEL/SETUP
Sound Customizing
SUBW ON (Initial setting) / SUBW OFF
SUBW BASS TREBLE BAL FADER DEFEAT
VOLUME SUBW
SUBW SYS 1 (Initial setting) / SUBW SYS 2
SUBW SYS 1: Subwoofer level changes according to the main
volume setting.
SUBW SYS 2: Subwoofer level change is different from the main
volume setting. For example, even at low volume
settings, the subwoofer is still audible.
Visual Customizing
DIM AUTO (Initial setting) / DIM MANUAL
SCR TYPE1 / SCR TYPE2 (Initial setting)
SCR TYPE1: The characters scroll from right to left, a
single character at a time.
SCR TYPE2: Words are built up from left to right, a single
character at a time. When the display is filled,
it is cleared and the remaining words are
displayed the same way until all words of the
title have been shown.