Panasonic ER2171 - Manual (Page 6)

6
English
If washing in water
The following is the symbol of washable trimmer. The
symbol means that hand‑held part may be cleaned
under water.
Warning ‑ Detach the hand held part from the power cord before
cleaning it in water.
1. Disconnect the power cord from
the trimmer.
2. Remove the blade.
3. Rinse off any hair trimmings that
are sticking to the blades with
running water.
4. Rinse out any hair trimmings that are
inside the trimmer with running water.
5. Gently shake the trimmer 4 or 5 times and then wipe off
any water drops from the trimmer and the blade.
6. Place the trimmer on a towel with the switch on the
main body facing downwards to let it dry fully.
Lubrication
Lubricate the blades before using
them or after cleaning them.
1. Apply a drop of the oil to the points
indicated by the arrows.
►
Remounting the blade
Fit the mounting hook into the blade mounting on the trimmer
and then push in until it clicks.
Blade life
Blade life varies according to the frequency and length of use of
the trimmer.
For example, the blade life is approximately 3 years when using
the trimmer for 10 minutes every 3 days. Replace the blades if
cutting efficiency reduces substantially despite proper
maintenance.
Battery life
Battery life varies according to the frequency and length of use of
the appliance.
For example, the battery life is approximately 6 years when the
battery is charged 3 times a month.
The appliance should not be left for more than 6 months without
charging it. The charge drains from the battery and the battery life
may be shortened.
Removing the built-in rechargeable battery
The battery in this trimmer is not intended to be replaced by
consumers. However, the battery may be replaced at an
authorized service center.
The procedure described below is intended only for removal of the
rechargeable battery for the purpose of proper disposal.
1. Disconnect the power cord from
the trimmer.
2. Remove the blade from the
trimmer. Remove the screw (a)
and detach the bottom cover (b).
3. Detach the dial cover (c), remove
the screw (d) and disconnect the
dial (e).
4. Remove the 2 screws (f).
(a)
(b)
(c)
(d)
(f) (e)
►
►