ALESIS WILDFIRE 30 - Manual (Page 17)

A Tour of the Wildfire
3
15
Fuse
Power Cord
FOOTSWITCH UP/DOWN INPUTS
EXPRESSION PEDAL INPUT
AUX INPUT
STEREO LINK OUTPUT
SPEAKER OUTPUT
Rear Panel
All three Wildfire models offer the rear-panel features
described here:
Fuse
The fuse protects the Wildfire from damage caused by a
defective AC outlet. If this fuse blows, you must replace it.
Power Cord
Plug the power cord into an AC outlet. The AC voltage
required is fixed at a single voltage based on the country
in which you purchased your Wildfire. The voltage is
not switchable (i.e., 110/220) or universal (i.e., 90-240).
Be sure to connect it to the proper voltage as indicated
in the information found on the rear panel.
FOOTSWITCH UP/DOWN Inputs
Here you can plug in standard footswitches to use for
incrementing and decrementing program numbers. The
foot switches work in the same way as the Program Up
and Program Down buttons. These jacks accept 1/4”
plugs.
EXPRESSION PEDAL INPUT
This input is for an optional expression pedal, which
gives you the ability to control effect parameters with
your foot. All effects listed in chapter 10 that have
“Pedal” in their names provide this capability. See
chapter 10 for a complete list of parameters. This jack
CAUTION: Danger of
fire or electrocution
exists if the fuse is
incorrectly replaced.
Replace it only with the
same or equivalent type
of fuse recommended by
the information found
next to the fuse.
We recommend that you
purchase footswitches
to use with your
Wildfire. They aren’t
very expensive, and
they greatly streamline
your interaction with
the amplifier,
particularly when
playing live.