Panasonic SCHC35EP - Manual (Page 16)

16
RQ
T
X
12
65
Listening to audio from a
USB device
Devices which are defined as USB mass storage class:
USB devices that support bulk only transfer
USB devices that support USB 2.0 full speed
The USB connectivity enables you to connect and play MP3
tracks from a USB device.
Preparation:
≥ Before connecting any USB device to this unit, be sure to back
up the data.
≥ It is not recommended to use a USB extension cable. The
device connected via the cable will not be recognized by this
unit.
1
Plug the USB device into the unit. (> 5)
2
Press [EXT-IN, RADIO] repeatedly to select
“USB”.
3
Press [1/;] to start play.
≥ Before removing the USB device, select a source other
than “USB”.
≥ Removing the USB device while it is selected can damage the data stored in
the device.
Others
Other Panasonic audio/video equipment may start functioning
when you operate the unit using the supplied remote control.
You can operate this unit in another mode by setting the remote
control operating mode to “REMOTE 2”.
The main unit and remote control must be set to the same
mode.
1
Press [EXT-IN, RADIO] to select “AUX”.
2
Press and hold [RADIO/EXT-IN] on the main
unit and [2] on the remote control until the main
unit’s display shows “REMOTE 2”.
3
Press and hold [OK] and [2] on the remote
control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps
above by replacing [2] with [1].
When the following situations occur, reset the memory:
≥ There is no response when buttons are pressed.
≥ You want to clear and reset the memory contents.
1
Disconnect the AC mains lead. (Wait for at least
3 minutes before proceeding to step 2.)
2
While pressing and holding down
[Í/I] on the main unit, reconnect the AC mains
lead.
“--------” appears on the display.
3
Release [Í/I].
All the settings are returned to the factory preset. You will
need to reset the memory items.
Compatible devices
Notes on USB
≥ Supported format: Files with extension “.mp3” or “.MP3”
≥ CBI (Control/Bulk/Interrupt) is not supported.
≥ FAT12, FAT16 and FAT32 file systems are supported.
≥ Depending on the sector size, some files may not work.
≥ This unit can access up to 254 albums (excluding Root folder) and 2500
tracks.
≥ The maximum number of tracks in a folder is 999 tracks.
≥ Only one memory card will be selected when connecting a multiport USB
card reader, typically the first memory card inserted.
≥ Disconnect the USB card reader from the unit when you remove the
memory card. Failure to do so may cause malfunction to the device.
≥ When you connect the digital audio player to the USB port, it charges all
the time when the unit is on.
USB operations
Stop Press [∫].
≥ The position is memorized while “RESUME” is
displayed.
Press [1/;] to resume play.
Press [∫] again to clear the position.
Pause Press [1/;].
≥ Press [1/;] again to restart play.
Skip Press [:] or [9]. (Track)
Press [3, 4]. (Album)
Direct access play
(Play starts with
the track you
select.) 1 Press [ 3, 4] to select the album.
2 Press [ 9] once and then the
numeric buttons to select the track.
For other operating functions, they are similar as those
described in “Disc operations”.
Changing the main unit and
remote control mode
Memory reset (Initialization)
SC-HC55_35-RQTX1265.book 16 ページ ２０１１年３月２７日 日曜日 午後７時３２分