AstroStart 2305A - Manual (Page 21)

19
ALARM CONDITION CODES
Use this command to identify which zone is in violation during arming or which generated alarm condition.
Press (2 sec.) on the button, then press the
and buttons simultaneously (2 sec.). Parking lights will flash a
number of times corresponding to code for protection zone in violation.
If more than one zone is in violation, code for the zone with highest priority is shown.
See table of codes below.
Code Protection Zone Priority
1 System is armed. 8
2 A door is/was open. 1
3 Hood is/was open. 3
4 Alarm condition is/was detected on shock sensor input. 5
5 Key is/was in the RUN position. 2
6
Alarm condition is/was detected on additional sensor input.
Additional sensor monitors status of ___________________________________________________
4
7 Loss of power (+12V battery supply was removed). 7
8 More than 3 warnings were given within 3 minutes by pre-shock input. 6
GLOSSARY
S
IREN
Siren has six different sounds, i.e., it chirps repeatedly and has six different melodies (supplied with optional alarm kit only).
It chirps intermittently (short repeated chirps) during a pre-alarm and continuously during an alarm condition.
It can confirm ARM and DISARM commands with short chirps (see table in CONFIRMATION section on page 13).
This function is programmable as ACTIVE or INACTIVE during installation.
H ORN
Horn beeps intermittently (short repeated beeps) during an alarm condition.
This function is optional and may require the installation of additional material.
Ask your installer for more details.
P ARKING LIGHTS
Parking lights flash intermittently (repeated flashes) during a pre-alarm and alarm condition.
Parking lights also confirm that commands have been received (see table in CONFIRMATION section on page 13).
V IOLATION
Violation means a situation that causes a protection zone to generate an alarm condition; example: a door was opened, etc.
D OME LIGHT DURATION
The system may turn the vehicle dome light on for 30 seconds upon unlocking command or when engine is stopped
(dependind on program - optional connection - not applicable in ‘semi-passive rearming’ mode).
On some vehicles, dome light may remain on after all doors have been closed.
If this option applies to your vehicle, rearming cycle is prolonged by the number of seconds during which dome light is kept
on by vehicle's factory system.
Special condition
If during dome light duration, a ‘Lock’ command is sent while a door is opened, system arms and ignores door
violation; if door is still open 45 seconds after dome light duration ends, system recognizes door violation and
changes to alarm condition.