Advantech PENTIUM PPC-150 - Manual (Page 124)

108 PPC-150 User's Manual
PM Control by APM
The option "No" allows the BIOS to ignore the APM (Advanced Power
Management) specification. Selecting "Yes" will allow the BIOS to wait
for APM's prompt before it enters Doze mode, Standby mode, or Suspend
mode. If the APM is installed, it will prompt the BIOS to set the system
into power saving mode after all tasks are done.
The options are: Yes (Default), No.
Video Off Option
This feature provides the selections for the video display power saving
mode. The option "Susp, Stby → Off" allows the video display to go
blank if the system enters Suspend or Standby mode. The option "Suspend
→ Off" allows the video display to go blank if the system enters Suspend
mode. The option "All Modes → Off" allows the video display to go
blank if the system enters Doze mode or Suspend mode. The option
"Always On" allows the video display to stay in Standby mode even when
the system enters Doze or Suspend mode.
The options are: Susp, Stby
→ Off (Default), Suspend → Off,
All Modes → Off, Always On.
Video Off Method
"DPMS Supported" allows the BIOS to blank off the screen display with
your VGA card which supports DPMS (Display Power Management
Signaling function). "Blank Screen" allows the BIOS to blank the screen
display by turning off the red-green-blue signals.
The options are: DPMS Supported (Default), Blank Screen.
Doze Speed (div by)
The options are: 2 (Default), 1, 3, 4, 5, 6, 7, 8.
Stdby Speed (div by)
The options are: 3 (Default), 1, 2, 4, 5, 6, 7, 8.
MODEM Use IRQ
This feature allows you to select the IRQ# to meet your modem's IRQ#.
The options are: 3 (Default), 4, 5, 7, 9, 10, 11, NA.