Audiovox Seven Channel Code Learning Programmable Receiver XR9000 - Manual (Page 14)

128-7863
14 of 20
Page 14
When the Panic Mode has been activated and the system is
armed the vehicle's lights will flash, the siren and lock icon
will be displayed on the LCD screen and the siren will beep. If
the system is disarmed and the Panic Mode is activated, the
lights will flash unlock icon will be displayed and the siren will
beep on the LCD screen.
When ever the vehicle is operated from the two way transmitter, the unit will
beep responsive to the function executed at the vehicle. 1 beep when armed, 2
beeps when disarmed, etc... at times It may be inconvenient or too noisy to
hear the beep tones, so the system allows you
to set the unit for vibrate mode. To toggle on or
off beep tones/vibrate, Simultaneously press the
"F" and unlock buttons. The icons shown left will
appear in the upper left hand corner of the
screen to indicate vibrate..
If the alarm system has been triggered, the icon displayed on the transmitter
LCD will indicate which zone has been activated, as well
sound the beep tones, or vibrate dependent upon the setting
as shown above. The following trigger patterns will be
displayed.
Triggered and the entry attempt was made to one of the
vehicle Doors.
Triggered and entry attempt was made to the vehicles Hood
or
Trunk.
Triggered and entry attempt was made to the vehicles glass, or
the vehicle has been hit or bumped hard enough to cause a
response from the vibration detector.
ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:
If the arm/disarm chirp tones have been turned off at the ve-
hicle, when you arm, or disarm, the display will indicate this as
shown and there will be no arm/disarm chirps at the transmit-
ter. This is true if the transmitter is set for vibrate mode.
When the vehicle is armed, and a door is opened, or ajar, the
transmitter will chirp 3 times, the lights will flash, and the display
will indicate a door trigger as shown on the previous page. When