Audiovox Seven Channel Code Learning Programmable Receiver XR9000 - Manual (Page 17)

128-7863
17 of 20
Page 17
activated at the vehicle, you can toggle the feature on simultaneously pressing
the Lock + Option buttons of the transmitter. The 24 hour icon will appear and
the transmitter will emit a tone confirming the feature is active.
Note: the unit will start once and run for the prescribed time. If you require more
frequent starting please refer to auto start up timer mode shown earlier in this
guide.
NOTE: To insure accurate 24 Hour Start up, it is advisable to reset the start time
periodically as time may drift slightly each day.
Timing Count Down:
The unit offers an additional count down timer for situations where an
alert tone may be needed to remind you of something important. For
instance you may have a meeting 4 hours from now and you want a
reminder in 3 Hrs and 45 Mins. This additional count down timer allows
you to set the count down up 19 Hours and 59 Minutes from the current
time and when the timer reaches zero, the transmitter will emit a tone or vibrate
dependent on your preferred setting. See chart for setting the count down time
for this feature.
Valet:
When the System is in the valet mode, the icon shown will show
in the display when the status check buttons are activated.
Parking Meter Counter:
The transmitter has a built in clock that can count down from 10, 20, 30, 60, 90,
or 120 minutes. This feature is useful when parking the vehicle in a metered
parking lot. If the time on the parking meter is 30 minutes, you can set the
count down timer to 20 minutes. The transmitter will emit a beep tone when
the timer expires to remind you to get back to your vehicle. See following chart
for setting the parking meter count down timer feature.
Alarm Clock Mode:
The transmitter has a built in alarm clock that can be set to beep at
a certain time each day. The alarm clock mode must be set, and
the feature turned on. To use this feature please refer to the chart
on the following page.
NOTE: Your system is shipped with two transmitters, 1 two way,
shown on the left and the one way transmitter, shown right. The one
and two way transmitters are programmed from the factory with
separate lock & unlock buttons, the trunk/key icon button
operates remote start and remote trunk release where
applicable. The option button and any button combina-
tion may be programmed to operate various options.
Consult your installation center for button programming
and options that may have been added to your vehicle.
Although this is the default programming from the
factory, this can be changed for you to any configuration
you prefer. Please refer to the transmitter program
guides included with your kit.
NOTE: A maximum of two of either style transmitter may be pro-
grammed to your unit.