Avaya IP Office Phone - Manual (Page 42)

Page 42 - Initial Assembly Installing a New System
Page 42 - Installing a New System IP Office Installation Manual
Initial Assembly 40DHB0002USCL – Issue 9 (28th October 2003)
Dual Modem Module
An optional Dual Modem Module (see pages 10, 14 and 18) is fitted to an IP Office base
unit as follows:
Procedure
1. Remove the three fixing screws on the rear of cover.
2. Turn the unit over and remove the four fixing screws from the base.
3. Slide the cover from the unit.
4. Mount the module in position as shown below and secure with the two snap-in spacers.
5. Replace the cover and secure with the seven fixing screws.
CAUTION: While installing, ensure that you wear a ground wrist strap that is connected
to a suitable grounding point.