Panasonic CUG95KE - Manual (Page 10)

▲ 8
Insert the power supply plug into an
electrical outlet and open the front
panel.
Preparation (Indoor Unit • Remote Control)
1
Indoor Unit
■ Ensure that the power supply
plug is securely inserted.
A loose plug may cause a fire or an electric
shock.
!
Warning
2
POWER
LOW HIGH
SLEEP TIMER
POWERFUL
POWER MONIT OR POWER SLEEP TIMER
P O W E R MONITOR LOW HIGH Hold the panel openers
and pull.
Notes
•
If the unit is not going to be used for an extended period of time, turn off the
Power Supply. If it is left at the ON position, approximately 2.8 W of electricity
will be used even if the indoor unit has been turned off with the remote control.
When standby mode is activated, approximately 35 W of electric power will be
consumed on the heat of compressor to warm up the room quickly. This mode
can be switched off if you do not require it. Please consult your dealer.
•
If operation is stopped, then restarted immediately, the unit will resume
operation only after 3 minutes.
3 Insert the air filters and close the front
panel.
POWER
LOW HIGH
SLEEP TIMER
POWERFUL
POWER MONIT OR
POWER LOW HIGH SLEEP TIMER
POWERFUL
POWER MONIT OR
Lift up slightly,
then pull down.
DBT
WBT
DBT
WBT
DBT
WBT
DBT
WBT
COOLING
32
23
43
26
30
–
24
18
Indoor
Outdoor
Indoor
Outdoor
HEATING
DBT: Dry Bulb Temperature
WBT: Wet Bulb Temperature
Max. Temperature
Use under the following conditions:
16
11
16
11
2
–
–5
–6
Min. Temperature
Unit in °C
Air filters
Air purifying filters
Insert the new
air purifying
filters. (Be sure
the “FRONT”
mark is facing
you).
Remove the air filters and insert the
air purifying filters.
POWER LOW HIGH SLEEP TIMER
POWERFUL
POWER MONITOR
3 min.