Panasonic SCAK240 - Manual (Page 5)

5
RQT8043
RQTV0061
LANG - 5
LANG - 4
FRANÇAIS
DANSK
ENGLISH
Step 2
- Inserting batteries into the remote control
AA/R6/LR6
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of time.
Store in a cool, dark place.
• Replace if the unit does not respond to the remote control even when held
close to the front panel.
• Do not use rechargeable type batteries.
• Mishandling of batteries in the remote control can cause electrolyte leakage,
which may cause a fi re.
• If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any part of
your body.
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to fl ame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
• put heavy objects on the remote control.
• spill liquids onto the remote control.
■ Use
Aim at the remote control sensor, avoiding obstacles, at a maximum range
of 7 m (23 feet) directly in front of the unit.
Refer to page 6 for the remote control sensor position.
Step 3
- DEMO function - DEMO function
When the unit is fi rst plugged in, a demonstration of its functions may be shown
on the display.
If the demo setting is off, you can show a demonstration by selecting “DEMO
ON”.
Press and hold [DISPLAY, –DEMO].
The display changes each time the button is held down.
NO DEMO (off)
Ô DEMO ON (on)
While in standby mode, select “NO DEMO” to reduce power consumption.
Note:
DEMO function cannot be turned on when DIMMER is on.
Placement of speakers
AK340
Place the front speakers so that the tweeter is on the
inside.
Tweeter
AK240
Speakers are designed identically so that no left or right
channel orientation is necessary.
You cannot take the front net off the speakers.
Use only the supplied speakers.
The combination of the main unit and speakers provide the best
sound. Using other speakers can damage the unit and sound
quality will be negatively affected.
Note:
• Keep your speakers at least 10mm ( 13 /
32
˝) away from the system for
proper ventilation.
• These speakers do not have magnetic shielding. Do not place them
near televisions, personal computers or other devices easily infl uenced
by magnetism.
• You can damage your speakers and shorten their useful life if you play
sound at high levels over extended periods.
• Reduce the volume in the following cases to avoid damage.
– When playing distorted sound.
– When adjusting the sound quality.
Caution
• Use the speakers only with the
recommended system. Failure to do so can
damage the amplifi er and speakers, and
can cause fi re. Consult a qualifi ed service
person if damage occurs or if a sudden
change in performance is apparent.
• Do not attach these speakers to walls or
ceilings.
RQTV0061-P_1EN.indd 5 RQTV0061-P_1EN.indd 5 10/18/05 1:12:30 PM 10/18/05 1:12:30 PM