AVE VSI-PRO User Manual

Page 43

Advertising

VSI-Pro VIDEO SERIAL INTERFACE

PORT 1 TEST

Sending and receiving data performance can be analyzed under the PORT 1 TEST sub-menu. Press the “Up” or
“Down” button to move the cursor to “PORT 1 TEST” and press “Set”. The following sub-menu will appear:

Figure 70: PORT 1 TEST Sub-Menu

RECEIVE [ RX ] TEST

The purpose of this test is to determine that if VSI-Pro is receiving the data or not. Press the “Up” or “Down” button to
move the cursor to “RECEIVE [ RX ] TEST”. The following display will appear (example only):

Receiving data will be appear in three sperate lines, scrolling from right to left. The first line is the actual ASCII data
coming from the register while last two lines are HEX conversion of ASCII data. If you do not receive any data, check
the connections between VSI-Pro and Register or any additional interfacing device.

Press “Set” to return to the previous menu.

RECEIVE [ RX ] TEST
TRANSMIT [ TX ] TEST
RX/TX TEST
BAUD RATE SCAN
EXIT

Figure 71: RECEIVE [ RX ] TEST Display

TRANSMIT [ TX ] TEST

The purpose of this test is to determine that if the VSI-Pro is able to transmit data or not. Press the “Up” or “Down”
button to move the cursor to “TRANSMIT [ TX ] TEST” and press “Set”. The following display will appear (example
only):

If VSI-Pro transmitting data you will see some predefined ASCII character on the screen. If you don’t see any
characters on the screen, check the connections and try again.

Press “Set” to return to the previous menu.

Figure 72: TRANSMIT [ TX ] TEST Display

RX BAUDRATE :

AUTO

TX BAUDRATE :

2400

PARITY :

NONE

DATA BIT :

HANDSHAKING :

OFF

TRANSMITTING :
BAUDRATE DETECTION..