AVE VSI-PRO - Manual (Page 45)

45
VSI-Pro VIDEO SERIAL INTERFACE
Figure 75: DATA CAPTURE Sub-Menu
Press “Set” to return to the previous menu.
CAPTURE TO PORT 1
This feature redirect the incoming data to VSI-Pro to its output ( Pin 3 of AT type RS-232 female connector ) where
that data can be stored to data storing devices (e.g. PC). This feature is useful to store non-RS 232 format data.
Press the “Up” or “Down” button to move the cursor to “CAPTURE TO PORT 1 and press “Set”. The following display
will appear (example only):
CAPTURE TO PORT 1
CAPTURE TO MEMORY
DUMP MEMORY
EXIT
DATA CAPTURE
This feature allow user to store the data either internal memory of VSI-Pro or some external data storing device.
Press the “Up” or “Down” button to move the cursor to “DATA CAPTURE” and press “Set”. The following sub-menu
will appear:
Press “Set” to return to the previous menu.
CAPTURE TO MEMORY
This feature allow you to store the data in the internal memory of VSI-Pro. You can store up to 20 kilobytes of data in
the internal memory of VSI-Pro. Power up the VSI-Pro for 24 hours prior to download of data. This will provide VSI-
Pro’s internal battery a full charge to hold data in its memory. Press the “Up” or “Down” button to move the cursor to
“CAPTURE TO MEMORY” and press “Set”. The following display will appear (example only):
Figure 76: CAPTURE TO PORT 1 Display
Figure 77: CAPTURE TO MEMORY Display
RX BAUDRATE : AUTO
TX BAUDRATE : 2400
PARITY : NONE
DATA BIT : 8
HANDSHAKING : OFF
BAUDRATE DETECTION..
RX BAUDRATE : AUTO
TX BAUDRATE : 2400
PARITY : NONE
DATA BIT : 8
HANDSHAKING : OFF
BAUDRATE DETECTION..
Press “Set” to return to the previous menu.
NOTE
?
VSI-Pro can only hold up to 20 kilobytes of data to make sure that you only transfer the
data which is in correct format.
PROGRAMMING