ATEN CS-228 - Manual (Page 25)

Stacking and Mounting
w
Stacking:
1. The unit comes with the stacking brackets already attached. Note that there is a top
and bottom half to each bracket. The top half has a convex surface; the bottom half
has a concave surface.
2. Line up the four bottom brackets of the top unit with the four top brackets of the bottom
unit; then fit the top unit down onto the bottom unit.
w
Rack Mounting
To rack mount the unit do the following:
1. First remove the stacking brackets by unscrewing them from the unit, as shown in the
diagram below:
2. Screw the mounting brackets into the sides of the unit, as shown in the diagram below:
3. Slide the unit into the rack and secure it to the rack.
2001-02-01
CS-228 User Manual 21