Panasonic TYST42PF3 - Manual (Page 5)

5
English
5
Installation procedure
Insert the two projections on the
stand into the two holes in the base
of the display as shown in the
illustration at left.
Insert and tighten the four
M5-30
screws, with two screws each at the
left and right.
2. Prepare the Wide Plasma Display.
Display unit
Cloth or similar
Remove the screws and covers and keep
them for possible future use.
*The screws may be used again if the
installation method is changed to the
waIl-stand method, so keep them in a
safe place so that they do not get lost.
• Spread a clean cloth or similar material over a level floor or base, and place the display unit on it face down.
• Lock the casters before installing the display.
N o t e
Note
3. Install the display to the stand.
Unlock
Lock
ST42PF3E改-4-11/10最終 00.11.22 8:48 AM ページ 5