Panasonic TC-60AS650U - Manual (Page 17)

- 17 -
Antenna / Cable service without a box
Initial setting
1. Connect coax
Connect a COAX wire from either an antenna or Basic Cable service to
the TV’s “ANTENNA/CABLE IN” screw terminal.
TV (ANTENNA/CABLE IN)
Antenna
2. Scan the channel
MENU Menu > Setup > ANTENNA/Cable setup > ANTENNA/
Cable signal , Auto program
1) Select either Cable or Antenna programming source in ANTENNA/
Cable signal .
2) Select Auto program and then the appropriate scan mode:
( All channels / Analog only / Digital only )
3) Start scanning.
● The tuner setup menu (auto scan, etc.) is only available when INPUT is
set to TV.
● If no channels are found by the end of the scan, then check the
following:
– Antenna’s position - or availability of Cable service.
– Cable, Satellite or Fiber Optic services with a box are typically
connected to the TV’s A/V inputs, preferably HDMI, for best HD
picture. In such a case, the channel scanning is not needed.