Panasonic EP-MA70CX - Manual (Page 25)

24
English
1 After the Automatic program has fi nished,
or when the massage is completed by
pressing during the program.
: Your preferred settings (pages 22–23, 42 (volume)) are
displayed and the User buttons will fl ash.
2 Select and press one button from
to store your settings
while the buttons are fl ashing (approx.
15 seconds).
• Selected button will light. (Example: )
To save your preferences
Automatic programs
You can save your preferred settings set during the Automatic programs, and have them reproduced next time you are being massaged.
You can save the settings for each program.
Example: When using the “REFRESH” program
1. You have set Air Massage “SHOULDER” and “LEG/FOOT” to “On”, and Stretch “CHEST” to “On”.
(Air intensity was set to “Level 1” at this time.)
2. “Heat” massage heads was set to “Off ”, and Back intensity was set to “Level 3”.
3. Volume for “voice guidance function” (see page 42) was set to “Loud”.
4. These settings were saved to User after the massage completed.
Contents of the saved settings (1, 2, and 3 above) are restored if User is pressed when the “REFRESH” program is used next time.
If there is another setting already saved, “Other settings are
already registered.” will be announced.*
To overwrite the contents with new settings*
press the same button again.
Press.
* This will also be announced when you try to save to a separate
Automatic program or save Automatic program contents that are
the same as those already saved.
If you do not want to delete the settings already saved
press another User button.
Press.
When saving your preferences is completed
• The pressed button will turn off , and the power of the
chair will be turned off automatically in approximately
3 seconds.
• Be careful since preferred contents will not be saved when the
power switch is turned “Off ” or the power cord is disconnected
during the massage.
Contents that can be saved
• Air intensity and Back intensity settings
• “Heat” Massage Heads on/off setting
• Air and Stretch on/off settings
(See pages 22–23.)
• Voice guidance volume setting (See page 42.)
* Settings at the time the Automatic program is completed
will be saved.
About the “Heat” massage heads and Voice guidance
volume settings
Only these 2 settings are applied to all the Automatic
programs.
For example, “Heat” massage heads “Off ” and Voice
guidance volume “Loud” of the settings saved to User
for “REFRESH” in the above “ Example” are applied, even
if User is pressed during a program other than
“REFRESH”. (The settings for Air and Stretch are not
applied.)
2