Panasonic HX-A100D User Manual
Page 29
29
VQT4X87
When disposing of your used products, delete
personal information from this unit by initializing
the network settings.
≥ Disassemble after the battery runs out.
≥ If it cannot be removed smoothly, contact
Panasonic’s Service Center.
≥ Keep disassembled parts out of reach of
children.
1
Open the side cover, and remove
all of the 6 screws indicated in the
figure below.
≥ Use a cross-slot screwdriver (commercially
available).
2
Remove the circuit board on the
front side (button side) of this unit,
and remove the flexible circuit
board
A.
3
After pulling out the built-in battery
connector
B, pull out the flexible
circuit board
C, and pull out the
speaker connector
D upwards.
4
Remove the 4 screws indicated in
the figure below, and remove the
heatsink
E.
5
Remove the connector
F of the
camera unit, and lift up the circuit
board.
6
Remove the battery by using a
screwdriver.
Regarding the handling of used batteries
≥ Insulate the terminals with cellophane tape or
similar.
≥ Do not disassemble.
How to remove the battery
This figure describes the disposal of this
unit, it is not instruction for repair. If
disassembled, repair is not possible.
HX-A100_VQT4X87_mst.book 29 ページ ２０１３年１月２５日 金曜日 午前９時５５分