Alen C475A - Manual (Page 8)

8
Remote Controller Display
Instructions for the remote controller
z The remote controller uses two AAA alkaline battrries. Under normal condition, the batteries last for
about 6 months. Please use two new batteries of similar type (pay attention to the poles in installing).
After replacing the batteries, please use a point object (such as pen tip) to press “Reset” button.
z The effective control distance of the remote controller is about 8 yards.
z When using the remote controller, please point the signal emitter towards the air conditioner receiver;
There should be no obstacles between the remote controller and the air conditioner.
z Do no press two buttons simultaneously on the remote control.
z Do not use wireless equipment (such as mobile phone) near the air conditioner. If interference occurs
because of this, please switch off the air conditioner, pull out power plug, then plug again and switch
on after a while.
z If direct sunlight is hitting the the receiver on the air conditioner it may not be able to receive the signal
from the remote controller.
z Take care not to drop theh remote control and keep from direct sunlight or heat sources.
z Keep the remote control dry, if it gets wet use a soft, dry cloth for cleaning.
z The batteries must be removed from the remote control before it is scrapped and disposed of safely.
Sleep Mode Display
Displayed when Pressing “SLEEP”
button the unit will enter into sleeping
operation.
Air refresh Display
(Not available)
AUH Display
It appears when
pressing the AUH
key is add in HEAT
mode.
Signal Emission
Symbol
It appears when
control signal is
emitted.
Display
displayed when
temp is displayed.
Time Display
Displays the time of
clock or timing
ON/OFF.
AUT
SET TEMP PROGRAM
Wind Speed Selection
Display
High speed
Medium speed
Auto
Low speed
AUT
Operating Mode Selection
Display Timer setting
Display
PROGRAM
ON timer
OFF timer
Program
Timer canceled
AUTO
COOL DRY
HEAT
FAN