ADT Security Services VISTA-15 - Manual (Page 23)

- 23 -
Bypassing Protection Zones
Using the 6 Key
BYPASS
This key is used when you want to arm your system with one or more
zones intentionally unprotected. Bypassed zones are unprotected and
will not cause an alarm when violated while your system is armed.
All bypasses are removed when an OFF sequence (security
code plus OFF) is performed. Bypasses are also removed if the
arming procedure that follows the bypass command is not successful.
The system will not allow fire zones to be bypassed.
To bypass zones, the system must be disarmed first.
1.
+ 6
(Security Code) BYPASS
Enter 4-digit security code, then
press the BYPASS key.
Example: Press 7 2 9 6 then 6
2.
(Zone Numbers)
Enter zone numbers.
Enter the zone number(s) for the zones to
be bypassed (e.g., 01, 02, 03, etc.)
.
Important! All single-digit numbers
must be preceded by a zero (for example,
enter 01 for zone 1).
3. B Y P A S S 0 7 F R O N T
U P S T A I R S B E D R O O M
Typical bypass message
Wait.
The keypad displays the word BYPASS
along with each bypassed zone number
(and a zone descriptor if programmed).
Wait for these zones to be displayed, to be
sure that intended zones are bypassed.
4. D I S A R M E D B Y P A S S
R e a d y t o A r m
Arm as usual.
Arm the system as usual when the
keypad displays the READY TO ARM
message.