Panasonic TYWK42PR7 - Manual (Page 4)

10
English
Installation procedure
• The wall-hanging bracket has installation holes provided in 14 locations.
If the wall material will not allow sufficient strength to be obtained from using six installation holes, use some of
the spare holes.
However, depending on the construction material used at the place of installation, cracks may develop if the
screws are inserted too close to each other.
Caution
• Use commercially-available M6 bolts which suit
the wall materials for installation to the wall.
Caution
The wall-hanging bracket weighs approximately 5.2 kg (19.85 lbs.) and the Plasma Display unit weighs
approximately 33 kg (72.8 lbs.) to 50 kg (110.2 lbs.).
While referring to the wall-hanging bracket installation dimensions in the diagram below, check the strength of
the wall in six installation locations, and add reinforcing if any of these locations are not strong enough.
1. Check the strength of the installation location.
• Install the wall-hanging bracket so that the arrow shown on the bracket is pointing upwards.
• If it is necessary to embed bolts or nuts beforehand because the wall is made from concrete, use the bracket
itself to determine the correct installation hole positions, or use the dimension diagram to calculate the hole
positions. Then embed the M6 bolts or nuts into the holes. Furthermore, when embedding the bolts, allow the
bolts to protrude from the wall by 10 mm (
13 /
32
inches) to 15 mm ( 19 /
32
inches) .
2. Install the wall-hanging bracket to the wall.
Installation procedure
1. First screw a bolt into the center-top hole.
2. Use a level gauge to correct the alignment
of the wall-hanging bracket, and then
screw bolts into the remaining five holes.
775 (30 33 /
64
)
486 (19
9
/ 64
)
450 (17
23
/ 32
)
18 (
45
/ 64
)
372.5 (14 43 /
64
) 372.5 (14 43 /
64
) 15 ( 19 /
32
)
15 ( 19 /
32
)
Wall installation holes (6 locations)
18 (
45
/ 64
)
Units: mm (inches)
• The marks indicate the centerline of the Plasma Display.
Note
Marks