Accton Technology EC3805 - Manual (Page 8)

8
Chapter 2: System Requirement and Installation
System Requirement
To access the NAT Smart Router via Ethernet, the host computer must meet the following
requirements:
 Equipped with an Ethernet network interface.
 Have TCP/IP installed.
 Allow the client PC to obtain an IP address automatically or set a fixed IP address.
 With a web browser installed: Internet Explorer 5.x or later.
The NAT Smat Router is configured with the default IP address of 192.168.1.254 and
subnet mask of 255.255.255.0. Considering that the DHCP server is Enable by default, the
DHCP clients should be able to access the Smart Router, or the host PC should be assigned
an IP address of the same subnet and related subnet mask (for example, IP address of
192.168.1.100 and subnet mask of 255.255.255.0) first for initial configuration.
After configuring the IP of host PC, you also can manage the Smart Router through a
web-based manager. The ADSL Router manager uses the HTTP protocol via a web browser
to allow you to set up and manage the device.