APW Wyott M Series - Manual (Page 5)

c) Remove Top Front Panel (Item 4A) by gripping rear edge and lifting up. The Bottom Front
Panel (Item 4B) can then be removed by holding the top edge with one hand and the bottom
edge with the other hand, then lifting panel up.
d) Cut and remove the nylon tie securing the conveyor. (Note: to remove for cleaning, see
"Disassembly" instructions.)
e) Replace Bottom and Top Front Panels (Items 4A & 4B), Butter Pan (Item 3) and Butter Roller
(Item 2).
4. BUN CHUTE/FEEDER/SUPER FEEDER INSTALLATION
M-83/M-83D: Install Bun Chute/Feeder (Item 7) by fitting slots on each side onto back panel studs
located at top rear of unit.
.
M-91: Install Feeder/Super Feeder (Item 7) by sliding feeder support "legs" into channels
located at top rear of unit.
5. INSTALLATION OF OPTIONAL TEFLON SHEET FOR DRY OPERATION AND/OR INCREASED
EASE OF CLEANING
NOTE: Apply light coating of oil to grill surface prior to installation of Teflon sheet.
M-83 & M-91
a)
Lay Teflon Sheet on flat surface.
Measure approximately 2" from end of
sheet. Notch corners as needed. Fold
under 2" long flap. Crease Teflon
Sheet at 2" fold.
b) Remove Super Feeder (bun chute).
From rear of Teflon Sheet retainer
bracket, slip 2" fold of Teflon Sheet
under bracket. Bring balance of sheet
forward and smooth sheet down
against grill plate.
c) Reinstall Super Feeder bun chute.
M-95
a)
Slide one' end of teflon sheet beneath
conveyor to bottom of grill plate.
b) Place other end of teflon sheet over
top edge of grill plate.
c) Install teflon sheet retainer over teflon
sheet and grill plate.
Teflon Sheet
Teflon Sheet
Retainer Bracket
Grill
Plate
M-83 & M-91
M-83 Teflon Sheet Kit P/N 87449
M-91 Teflon Sheet Kit P/N 83764
M-95
M-95-2 Teflon Sheet Kit P/N 84177
M-91-3 Teflon Sheet Kit P/N 84176
5