Atmel ATAVRAUTO100 - Manual (Page 4)

Introduction
1-5 ATAVRAUTO100 User Guide
7697B–AUTO–09/07
1.2 ATAVRAUTO100 Features
The ATAVRAUTO100 provides the following features:
AT90CAN128 QFN64,
AVR Studio software interface (Note:) ,
Power supply:
– regulated 5.0V out of the VBAT (typical 12V) from the LIN connector
JTAG connector:
– for on-chip In Situ Programming (ISP)
– for on-chip debugging using JTAG ICE
Serial interfaces:
– 1 CAN interface (High Speed and Low Speed)
– 1 LIN interface 1.3 and 2.0 compliant (Software library available on the Atmel
website for LIN 1.3).
On-board resources:
– 1 high speed CAN transceiver ATA6660
– 1 LIN transceiver ATA6621 implementing one 5.0V voltage regulator and a
watchdog
– 1 blue LED
1 Jumper to add a 1KΩ pull-up resistor when Master mode is selected (LIN)
On-board In Situ Programming jumper
System clock:
– 8 MHz crystal
Dimension: 45 mm x 45 mm
Note: The AT90CAN128 is supported by AVR Studio, version 4.12 or higher. For up-
to-date information on this and other AVR tool products, please consult our web
site. The newest version of AVR Studio, AVR tools and this user guide can be
found in the AVR section of the Atmel web site, http://www.atmel.com.