Airlink ARW027 - Manual (Page 21)

15
WIRELESS BROADBAND ROUTER CONFIGURATION
First make sure that the network connections are functioning normally.
This Wireless Broadband Router can be configured using Internet
Explorer 4.0 or newer web browser versions.
Login to the Wireless Broadband Router through WLAN
Before configuring the Wireless Broadband Router through WLAN, make
sure that the Operation Mode, SSID, Authentication, and the WEP
settings of your wireless adapter are set properly:
Operation Mode: Infrastructure
SSID: default
Authentication: Open
WEP Encryption: disabled
Login to the Wireless Broadband Router through LAN
Before you configure this device, note that when the Wireless Broadband
Router is configured through an Ethernet connection, make sure the host
PC must be set on the IP subnet that can be accessed by the xDSL/Cable
modem. For example, when the default network address of the
xDSL/Cable modem Ethernet interface is 192.168.1.x, then the host PC
should be set at 192.168.1.xxx (where xxx is a number between 2 and
254), and the default subnet mask is 255.255.255.0.
Using the Web Browser
1. Open Internet Explorer 4.0 or above Internet browser.
2. Enter IP address http://192.168.1.1 (the factory-default IP address
setting) in the URL web address location.