Panasonic SC-PM200 - Manual (Page 11)

E
N
G
L
IS
H
ENGLISH
RQT9547
11
11
Maintenance
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
Specifications
Amplifier section
RMS output power stereo mode
Front Ch (both ch driven)
10 W per channel (6 ), 1 kHz, 10% THD
Total RMS stereo mode power 20 W
FM/AM tuner, terminals section
Preset station FM 30 stations
AM 15 stations
Frequency modulation (FM)
Frequency
range
87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals 75 (unbalanced)
Amplitude modulation (AM)
Frequency
range
522 kHz to 1629 kHz (9 kHz step)
520 kHz to 1630 kHz (10 kHz step)
Headphones jack
Terminal
Stereo, 3.5 mm jack
Music port (top)
Terminal
Stereo, 3.5 mm jack
Disc section
Disc played (8 cm or 12 cm)
CD, CD-R/RW (CD-DA, MP3 formatted disc)
MPEG-1 Layer 3, MPEG-2 Layer 3
Pick up
Wavelength
790 nm (CD)
Laser power CLASS 1 (CD)
Audio output (Disc)
Number of channels
2 ch (FL, FR)
FL = Front left channel
FR = Front right channel
USB section
USB port
USB standard
USB 2.0 full speed
Media file format support MP3 ( .mp3)
USB device file system FAT 12, FAT 16, FAT 32
USB port power 500 mA (max)
Speaker section
Type 1 way, 1 speaker system (bass reflex)
Speaker unit(s)
Full range
10 cm cone type
Impedance 6
Output sound pressure
83 dB/W (1 m)
Frequency range 61 Hz to 17 kHz (–16 dB)
95 Hz to 15 kHz (–10 dB)
Dimensions (W x H x D) 139 mm x 224 mm x 138 mm
Mass 1.3 kg
General
Power supply AC 220 to 240 V, 50 Hz
Power consumption 12 W
Dimensions (W x H x D) 153 mm x 224 mm x 232 mm
Mass 1.7 kg
Operating temperature range 0°C to +40°C
Operating humidity range
35% to 80% RH (no condensation)
Power consumption in standby mode
0.2 W (approximate)
Note:
1) Specifications are subject to change without notice.
Mass and dimensions are approximate.
2) Total harmonic distortion is measured by the digital
spectrum analyzer.
Memory reset (Initialisation)
When the following situations occur, refer to the
instructions below to reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset the memory
1 Disconnect the AC mains lead.
(Wait 3 minutes before you continue with step 2.)
2 While you press and hold [1] on the main unit,
connect the AC mains lead again.
“– – – – – – – –” shows on the display panel.
3 Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
PM200_EP_1gb.indd 11 PM200_EP_1gb.indd 11 5/9/2011 5:15:50 PM 5/9/2011 5:15:50 PM