Alpatronix HX200 Active Bluetooth Hands Free Headset - Manual (Page 4)

User Manual
4
Step III: Turn the headset on/off
Turning the headset On/Off:
i. Press and hold the #1 key for 2 seconds. This will turn on the device, turn all
LEDs on, and the device will emit a long beep.
ii. To turn the device off, simply press and hold the #1 key for 2 seconds again.
Note: In the event that your headset goes out of range of the device, it will automatically shut off after 3
minutes, in order to conserve battery power.
Step IV: Pair the headset to your device
Note: Pairing operations must be performed with the device turned OFF.
i. Place the mobile phone or other digital audio device into Bluetooth search mode.
ii. With the headset turned OFF, press and hold #1 key for about 5 seconds. This will place the
headset into pairing mode. This is indicated by red & blue lights flashing repeatedly.
iii. On your smartphone/audio device’s Bluetooth search list, find HX200.
iv. If prompted to enter a password, enter 0000.
v. After first-time pairing, the headset will automatically connect to your Bluetooth audio
streaming device so long as the Bluetooth function has been enabled on your device.
Therefore, for all consecutive operations, simply turn the headset on and listen for the pairing
beep.
vi. In the rare event that pairing is unsuccessful, make sure your device is not paired with any
other headset or speaker, and repeat the pairing steps again.
Note: If headset cannot find the pairing equipment in 3 minutes, it will automatically shutdown.
Note: If your device cannot find this headset, chances are the headset is not in pairing mode. Turn the
headset off, and follow above instructions to put the headset and your smart phone into pairing mode.
On/Off Switch