Avenview FO-HDMI-XX-MM - Manual (Page 9)

www.avenview.com 9
2.2 Power Consumption and DDC Power Requirements
Power consumption of FO-HDMI-XX-MM Transmitter and Receiver Module
Item maximum unit
s Transmitter 0.8 Watt
Receiver 1.05 Watt
Transmitter module of FO-HDMI-XX-MM without external power supply is operated by drawing out power for
DDC from the computer and receiver module of FO-HDMI-XX-MM cable also utilize the DDC power delivered
via copper wire.
2.3 Signal Pin Assignment
Transmitter / Receiver
Pin Signal Assignment Pin Signal Assignment Pin Signal Assignment
1 T.M.D.S. Data2+ 9 T.M.D.S. Data0- 17 DDC/CEC Ground
2 T.M.D.S. Data2 Shield 10 T.M.D.S. Clock+ 18 +5V Power
3 T.M.D.S. Data2- 11 T.M.D.S. Clock Shield 19 Hot Plug Detect
4 T.M.D.S. Data 1+ 12 T.M.D.S. Clock-
5 T.M.D.S. Data 1 Shield 13 CEC
6 T.M.D.S. Data 1- 14 Reserved (N.C on device)
7 T.M.D.S. Data 0+ 15 SCL
8 T.M.D.S. Data 0 Shield 16 SDA
If graphic board of the computer does not supply over 0.6A, 5V, FO-HDMI-XX-MM cable
may not operate normally.