CatEye CC-TR300TW [V3] - Manual (Page 8)

ENG-15
ENG
ENG-14
6. Operation test
Test the functioning of the speed sensor (SPEED) and the cadence sensor (CADENCE).
* If the sensor signal icons, , and are turned off, press the M1/+ or M2/- button to
turn them on.
Speed sensor (SPEED)
1. Raise the rear wheel and spin the wheel.
2. When flashes on the computer screen
and the speed is displayed, it is operating
normally.
Cadence sensor (CADENCE)
1. Turn the crank.
2. When flashes on the computer screen
and the cadence is displayed, it is
operating normally.
* When or does not flash, the position of the sensor and the magnet is not
proper. Check and adjust the position of the sensor and magnet again (page 7).
Important: In the following situations, it is possible that other sensor's ID was picked
up; (such can happen when performing ID Synch at the race venue or
group rides)
• Does not display values, even though sensor/magnet position is proper
• Does not display HR values, even though HR sensor is strapped properly
Recommended Action: Go to the computer's ID Synch setup screen
(page 23) and go through the process of ID Synch. (Make sure that here
is no similar devices in the vicinity. Signal transition distance can vary
from environmental conditions such as weather, buildings, etc)
3. Verify that the speed/cadence sensor is mounted properly to
the bicycle.
4. Press the SSE button to start searching the speed sensor ID.
When the speed (cadence) is displayed as “ID-OK” on the
screen by spinning the rear wheel or crank, searching is
completed.
Start searching:
SSE
5. Press the MENU button to proceed to “Selecting speed unit”
below.
To “Selecting speed unit”:
MENU
* This unit enters the search mode for 5 minutes after starting the ID check.
Press the SSE button during the search mode, then “ID-SKIP” is indicated and it
proceeds to “Selecting speed unit” screen below. Or, unless a sensor signal is
received in 5 minutes, “ID-ERROR” is indicated and it proceeds to “Selecting
speed unit” screen below.
When “ID-SKIP” or “ID-ERROR” is indicated, this unit is not ready for
measurement because the sensor ID has not been registered even though the
set-up is completed. Be sure to check the sensor ID from the menu screen
“Searching the sensor ID” (page 29).
5. Selecting speed unit
Select the speed unit from “km” and “mile”.
1. Select the speed unit.
km ↔ ↔ ↔ ↔ ↔ mile: M1/+
M2/-
2. After selecting, press the MENU button. The measurement
screen appears and the computer set-up is completed.
(or)
(Back)
Sensor signal status
If there is no incoming signal for approximately 5 minutes, the transmission stops
and no longer receive the sensor data.
Once you press the M1/+ or M2/- button, the computer will come out of the Sleep
mode and return to the Stand-by for sensor signal.
Signal transmission status can be checked with Signal icon.
(flashing) : Receiving sensor signal
(constant) : Stand-by for sensor signal
(off)
: Transmission off
* Transmission off status is independent for heart rate and speed/cadence sensor.
If both sensors stop transmission, the computer screen will change to Sleep
mode (page 17).