CatEye CC-PA100W [Padrone] - Manual (Page 11)

2
3
4
1
SET
Appendix
11
Warning / Caution
•
Do not concentrate on the computer while riding. Always ride safely.
•
Mount the magnet, sensor, and bracket securely, and check them periodically to en-
sure that they are not loose.
•
If a battery is swallowed accidentally, consult a doctor immediately.
•
Do not leave the computer in direct sunlight for a long period of time.
•
Do not disassemble the computer.
•
Do not drop the computer. Doing so may result in malfunction or damage.
•
When pressing the MODE button with the computer installed on the bracket, press the
area around the dot section on the front of the computer. Pressing other areas strongly
may result in malfunction or damage.
•
Always tighten the bracket band dial by hand. Using a tool or other object to tighten the
dial may crush the screw thread.
•
When cleaning the computer and accessories, do not use thinners, benzine, or alcohol.
•
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to local regulations.
•
The LCD screen may be distorted when viewed through polarized sunglass lenses.
Wireless Sensor
The speed sensor is designed with a maximum signal range of 70 cm (27”), to reduce
the chance of interference. (The signal range is intended to serve as a rough guide only.)
When handling the wireless sensor, note the following:
•
Signals cannot be received if the distance between the speed sensor and the computer
is too large.
•
Signal range may be shortened due to low temperature and flat batteries.
•
Signals can be received only when the back of the computer is facing the speed sensor.
Interference may occur, resulting in malfunction, if the computer is:
•
Near a TV, PC, radio, or motor, or in a car or train.
•
Close to a railroad crossing, railway tracks, TV transmitter station, or radar station.
•
Used with other wireless devices or certain battery-powered lights.
Appendix
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions:(1)This device may not cause harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired operation.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are
not expressly approved by CatEye Co., Ltd. May void the user ’s authority to operate the equipment.
Hereby, CATEYE Co., Ltd., declares that this CC-PA100W is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.