Standard accessories optional accessories, Troubleshooting, Maintenance – CatEye CC-RD310W [Strada Wireless] User Manual

Page 10: Replacing the battery, Ok no

Advertising
background image

Standard accessories

Optional accessories

STRADA WIRELESS

CC-RD310W

ENG

10

In use

Troubleshooting

The sensor signal icon does not fl ash.
(the speed is not displayed)

Check that the clearance between the sensor and magnet

is not too large. (Clearance: within 5 mm)

Check that the magnet passes through the sensor zone

correctly.

Adjust the positions of the magnet and sensor.

Is the computer installed at the correct angle?

Back of computer must face toward the sensor.

Check that the distance between the computer and sen-

sor is correct. (Distance: within 20 to 60 cm)

Install the sensor within the specifi ed range.

Is the computer or sensor battery weak ?
* In winter, battery performance diminishes.

If the computer reacts only when it is close to the sensor,

weak batteries may cause it.

Replace with new batteries according to the procedure

specifi ed in the section “Replacing the battery”.

Nothing is displayed by pressing the button.

Replace the computer battery according to the proce-

dure specifi ed in the section “Replacing the battery”.

Incorrect data appear.

Clear all according to the procedure described in “Pre-

paring the computer”.

All measured data are deleted.

Maintenance

To clean the computer or accessories, use diluted neutral

detergent on a soft cloth, and wipe it off with a dry cloth.

Replacing the battery

Computer

When the display becomes dim, replace the battery. Install a

new lithium battery (CR1616) with the (+) side faced upward.

* Press the top edge of waterproof

inner cap to remove it.

* After replacing the computer bat-

tery, follow the procedure described

in “Preparing the computer”

* Noting the total distance before replacing the battery allows

you to start from the total distance you enter manually after

replacing it.

Speed sensor

When the speed is not displayed even after adjusting cor-

rectly, replace the battery.

Insert new lithium batteries (CR2032) with the (+) sign up-

ward, and close the battery cover fi rmly.

* After replacement, check the positions of the sensor and

magnet.

1603894

Parts kit

1603895

Rubber band / nylon tie

1699691N

Wheel magnet

1603850

Lithium battery

CR1616

1665150

Lithium battery

CR2032

1602196

Speed sensor

(SPD-01)

1600280N

Bracket band

(FlexTight™)

1602194

Bracket kit

(FlexTight™)

1602193

Bracket

(for FlexTight™)

1603891

Speed sensor (SPD-02)

1604100

Out-front bracket

1603892

Bracket kit

COIN

Press

Waterproof inner cap

CR1616

Slide

OK

NO!

CR2032

Open

Close

Advertising