Figure 4.4 the ppc without the rear cover, 3 installing the 2.5" hard disk drive, Figure 4.4 – Advantech PPC-175T User Manual
Page 38: The ppc without the rear cover, Installing the 2.5" hard disk drive, Figure 4.5, Fastening the hdd metal frame to the hdd
Advertising
PPC-175T User Manual
24
Figure 4.4 The PPC without the Rear Cover
4.3
Installing the 2.5" Hard Disk Drive
One enhanced Integrated Device Electronics (IDE) hard disk drive may be attached
to the panel PC's internal controller which uses a PCI local-bus interface. The follow-
ing instructions are for installing the HDD:
1.
A metal plate holds the HDD to the upper right-hand side of the metal shielding
case. (See Fig. 4-5.) Fix the two screws on the metal plate of two side of HDD.
2.
Connect IDE cable from main board.
3.
Place the HDD on the metal plate, and tighten the four screws from the bottom
of the metal plate.
Figure 4.5 Fastening the HDD metal frame to the HDD
Advertising