Aastra Telecom BE-100HT - Manual (Page 10)

- 10 -
3. When you hear an incoming call ringing, push the BE-100HT
TALK button (7). The BE-100HT telephone will answer the call
and the IN USE LED will light.
4. Begin speaking normally into the microphone.
5. After completing your conversation, push the TALK button (7)
to hang up and disconnect the call. The IN USE LED will go
out.
ADJUSTING THE RINGER VOLUME
The volume of the telephone ringer can be adjusted by moving the
ringer switch (2) on the back of the BE-100HT either to the right
LOW or left HI.
TONE/PULSE SWITCH
The BE-100HT can dial outgoing calls using either TONE (DTMF)
or PULSE dialing. In most cases dialing in TONE mode is easier
and faster.
5. Set the TONE/PULSE switch (3) on the back of the BE-100HT
to choose the appropriate method of dialing.
2. If your telephone service only supports pulse dialing, you must
have this switch in the PULSE position.
REDIAL BUTTON
The REDIAL button (8) is used to quickly redial the last number
that was dialed using the dial pad.
OPERATION - continued