Figure 5-6. add a new route – ADC MM701G2 User Manual
Page 48
Chapter 5: Configuring System Parameters
5-6
2
To add a new static route, do the following:
a. On the Static Routes page, click Create a new IP route. The following dialog is displayed.
Figure 5-6. Add a New Route
b. Enter the following information for the static route.
– Destination
The IP address for the destination network, subnet, or host to which the packets are directed.
Use 0.0.0.0 as the destination IP address for a default route.
– Gateway
The IP address for the next hop in your network to which the packets are forwarded. The
gateway can be present either on the LAN or the WAN.
– Netmask
The network mask defining the route and access for the destination IP address.
– Cost
The number of hops (gateways) from 1 to 15 through which this traffic can pass before reaching
its destination.
c. Click Create. The new entry is added to and is displayed in the Static Routes table (see page 5-5).
Step
Action