View system log – ADC MM701G2 User Manual
Page 76
Chapter 9: Managing the Modem
9-2
The following is a description of the fields at the top of the Status page:
• Device Name
Identifies the modem and its LAN connection type (Ethernet port). This is not a configurable parameter.
• Firmware Release
Identifies the version number of the software image currently used on the modem.
• Model
Identifies the model of the modem.
• MAC Address
Identifies the unique, hardware address assigned to and resident on the modem.
• DSP Version
Identifies the version of the G.shdsl firmware driver used for the modem.
The following is a description of the fields in the Summary of current settings table:
• DSL Status
Provides configuration values specific to G.shdsl, including:
– Modulation—Indicates the G.shdsl transmission standard to which the modem is set.
– State—Status of the DSL link.
– Data Rate TX—Bit rate at which the is configured to send data.
– Data Rate RX—Bit rate at which the is configured to receive data.
– SNR Margin (DB)—Current SNR margin in decibels.
• WAN Session
“Configure a New WAN Session” on page 4-2
for definitions of WAN Session fields.
• LAN
“Configure the LAN” on page 3-1
for definitions of LAN fields.
View System Log
The Configuration Error Log shows errors that have occurred during the time the modem is operational. This error
log is used by the manufacturer for internal use only.
Select System on the menu bar, then select System Log under System to access the Configuration Error Log
page (