Pulsafeeder Chem-Tech Series XPV EN - Manual (Page 8)

REV. E PN J63091 - 8 -
Figure 4: Injector valve
5) Referring to Figure 5 slide ceramic strainer weight on suction
tubing first then remove the coupling nut from the strainer and slide
onto tubing next. Push the end of the tubing onto the strainer and
hand tighten the coupling nut. Hand-tighten only, do not use
wrenches. Note: Immerse tubing in hot water to soften prior to
pushing on fitting.
6) Install the strainer so it is off the bottom of the chemical
container (1 to 2-inches (25-50mm)) and measure suction tubing
length required. Cut tubing ends square and install on suction
fitting of the pump. Hand-tighten only, do not use wrenches.
5. Operation
WARNING: Always make sure the voltage on the pump data plate
matches the installation voltage before plugging the pump into a
wall outlet or hooking up to an electrical supply. If you are unsure, have a licensed
electrician inspect and install your pump.
AVERTISSEMENT: assurez-vous Toujours que le voltage sur la plaque de données de
pompe correspond au voltage d'installation avant le fait de brancher la pompe dans une
issue murale ou le fait d'agrafer aux réserves électriques. Si vous êtes peu sûrs, faites
inspecter un électricien agréé et installez votre pompe.
If your application requires a Cycle Timer or Daily Timer pump operation you must set
the time and day of week in the Configuration->Settings->Set Time menu. Because this
pump uses a small battery to keep the time and day information it is recommended that
the pump stay powered up initially for at least 24 hours to charge the battery once
installed.
The front panel includes an LCD display, six menu driven pushbuttons, and three
indicator lights. Below are the menu options that are available to the user to set the
different pumping modes as well as system settings.
Use the UP, DOWN, ENTER, and ESCAPE buttons to navigate the different menu
options.
Figure 5: Ceramic-
Weighted Strainer