Pulsafeeder Chem-Tech Series XPV EN - Manual (Page 9)

REV. E PN J63091 - 9 -
Indicator Lights:
Run: Illuminated when the pump is running or idle
Stop: Illuminated when the pump is stopped by the external stop signal
Fault: Illuminated when a fault condition occurs
Button functions:
Escape: Use this button to go back to the previous screen
Up/Down Arrow: Use these buttons to scroll through the menus
Prime: Push and hold this button to prime at fixed speed (default 100%)
Enter: Use this button to choose/accept menu lines
Stop: Use this button to stop the pump from running
Pump Modes:
Fixed Speed: Pump operates at a constant speed based on percentage of full
speed
Cycle Timer: Pump operates at set intervals and fixed speed based on
percentage of full speed
Daily Timer: Pump operates at set intervals, on set days at set times of the day
and fixed speed based on percentage of full speed
Pulse: Pump operates based on closed contact input pulse from the external
connector pins
4-20mA: Pump operates based on 4-20mA input signal from the external
connector pins
Configuration:
Pump Settings:
Prime Speed: Sets the priming speed of the pump based on percentage
of full speed
Auto Resume: Commands the pump to resume pumping when power is
restored if power was lost while the pump was operating
Set Time: Set the system day and time
Contrast: Adjusts the display contrast
Factory Reset: Resets the pump to the default settings
Run
Stop
Fault
Prime Stop Escape Enter
Down Arrow
Up Arrow