Mounting the axb-232 in an equipment rack – AMX Enhanced Master RS-232 Controller AXB-EM232 User Manual
Page 12
Product Information
8
AXB-EM232 Enhanced Master RS-232 Controller
5.
Carefully slide one battery out of its socket, and insert the new battery.
6.
Plug the 2-pin power connector in to reapply power. Wait one minute; then, remove the power
connector again.
7.
Carefully slide the other battery out of its socket, and insert the new battery.
8.
Plug in the 2-pin power connector.
9.
Slide the circuit board back into the enclosure.
10. Replace the front panel and refasten the two screws.
11. Reconnect any connectors you removed.
Mounting the AXB-232 In an Equipment Rack
To rack-mount the AXB-EM232 using an (optional) AC-RK Accessory Rack Kit:
1.
Remove any/all connectors from the rear panel.
2.
Remove the two screws on the front panel, and remove the front panel and the space bracket
behind the panel.
3.
Use a blade or other sharp object to remove the rubber feet on the bottom of the AXB-EM232
enclosure.
4.
Place the unit in the appropriate opening in the AC-RK.
5.
Place the front panel of the AXB-EM232 on the front of the rack over the unit, and secure.