6 installing the level wand – Pulsafeeder Digital Glycol Feeder DGF2 User Manual
Page 14
9
Refer to the Molex/Heat shrink sleeving procedure shown below while making the
connections outlined in sections 2.1.7, and 2.1.8.
1
Find Mating Connections.
2
Slide heat shrink sleeving over one of the connectors.
3 Assemble the connectors together.
4 Slide heat shrink over connection. Shrink sleeving and secure each end with a
cable tie as shown.
2.1.6 Installing The Level Wand
1. Insert the Level Wand in the hole provided in the tank cover.
2. Adjust the height of the wand to the alarm level required by loosening the adjustment lock
nut and sliding the wand through the adapter.
3. Tighten the adjustment lock nut.
4. Connect the level wand cable to the three position cable on the back of the controller, marked
“LEVEL WAND”.
Figure 8 – Level Wand Installation