Silver King SKFB48 - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING REFRIGERATORS AND FREEZERS
MODELS SKRB27, SKRB27D, SKFB27, SKFB27D, SKRB48, SKFB48
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the
most reliable equipment in the industry today. Please read this manual and the accompanying warranty
information before operating your new Silver King unit. Be sure to complete and mail the warranty card
within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to examine and test for possible damage
following the instructions printed on the exterior of the container. Report any damages to the carrier
responsible for transportation and promptly present a claim for any evidence of mishandling.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing
and shipping. This covering can be readily stripped before installation. After removing this covering, wash
the interior and exterior surfaces using a warm, mild soapy water solution and a sponge or soft cloth.
Location:
When locating your new Silver King unit, convenience and accessibility are important considerations, but
the following installation guidelines must be observed;
* Always avoid locating the unit adjacent to an oven, heating element or hot air source which could ad-
versely affect the performance of the unit.
* If the unit is not on casters, it is designed to be sealed to the floor with a waterproof sealant as required by
NSF International. To do so, locate the unit in its desired location (following the installation instructions),
apply a bead of sealant around the perimeter of the unit at the base and smooth out with a finger to form a
radius with the floor and the unit.
* The unit must be level.
* For proper ventilation, the bottom front of the unit must not be obstructed.
Shelves:
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with
the “tang” go on the rear Pilasters. This shelf system allows for easy adjustment to suit your needs.
Drawers:
To remove the Drawers on the drawer models for cleaning, simply open them fully, push the stop levers out
of the way on the Cabinet Drawer Tracks while pulling the Drawer out. To reinstall the Drawer, line up the
Drawer Tracks on the cabinet and the Drawer and push the Drawer into the cabinet. The Drawer Pan can
be removed by lifting it out with the Drawer extended.
Electrical Connections:
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting
the unit to a power source. The specifications on the data plate supersede any future discussion.