Silver King SK15MAJ - Manual (Page 2)

1
TECHNICAL MANUAL
MAJESTIC SERIES BULK MILK DISPENSERS
INSTALLATION, OPERATION AND MAINTENANCE
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most
reliable equipment in the industry today. Please read this manual and the accompanying warranty information before
operating your new Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to
validate your warranty.
Upon delivery of your new Silver King unit, inspect the carton and unit for shipping damages. Report any damage
immediately to the transportation carrier and file a written freight damage claim to protect your investment. If a claim is
to be filed, save all packaging materials.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping.
This covering can be readily peeled before installation. After removing this covering, wash the interior and exterior
surfaces using a warm mild soapy water solution and a sponge or cloth, rinse with clean water and wipe dry.
Drip Tray:
Follow the instructions supplied with the drip tray for mounting it to the unit.
Location:
When locating your new milk dispenser, convenience and accessibility are important considerations, but the following
factors must be observed:
* When placing the unit on a counter, the counter must be able to support a minimum of 300 pounds.
* When wall mounting the unit, follow the instructions supplied with the wall mounting kit.
* When placed on a counter, the unit must be on the legs supplied and secured to the counter with the Hold Down
Brackets supplied. If the legs are not installed the unit will not operate properly and the warranty will be void.
* There must be at least four (4) inches of clear space above the unit, two (2) inches on each side and back and open
in front.
* At no time should anything be stored or placed on top of the unit.
* Correct serving height is important so that those using the dispenser can operate the dispenser properly.
* The unit must be level. The feet on the front legs are adjustable to aid in leveling the unit.
* Avoid placing the unit next to an oven, heating element or hot air source which would adversely affect the performance
of the unit.
Electrical Connections:
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to
power. The specifications on the data plate supersede any future discussion.
The standard dispenser is equipped with a seven (7) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase
properly grounded electrical receptacle. The power cord comes with a 3 prong plug for grounding purposes. Any
attempt to cut off the grounding spike or to connect to an ungrounded adapter plug will void the warranty, terminate the
manufacturers responsibility and could result in serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker.