Vaddio WallVIEW 100 Technical - Manual (Page 42)

42
Command List
The EVI-D100/P translates the parameters to let the
camera obtain the same zoom position that is defined
by the D30/D31’s parameter.
The digital zoom function is always set to ON.
However, when you use the CAM_Zoom Tele/Wide
command or the Remote Commander, the available
zoom range is equal to the zoom range of the EVI-
D100/P (0000h to 7000h).
Translation when answering inquiry
commands
Parameters Translation
0000h to 7000h Translates within a rage of 0000h to 03FFh
The D100/P’s parameters are translated to those of the
D30/D31.
However, even if the zoom position value is less than
08D0h (closer to the wide side), the camera sends
back 0000h to the controller. On the other hand, even
if that value is greater than 5700h (closer to the
telephoto side), the camera sends back 03FFh.
Translating Parameters
Zoom speed
Cameras Parameters
EVI-D30/D31 02h (Min. speed) to 07h (Max. speed)
EVI-D100/P 00h (Min. speed) to 07h (Max. speed)
Translation of commands
Accepted parameters Translation
00h, 01h Translates to 02h
Values greater than 02h Accepts as is
Zoom position
Cameras Parameters
EVI-D30/D31 0000h (WIDE) to 03FFh (TELE)
EVI-D100/P 0000h (WIDE) to 7000h (TELE, digital 4 ×)
Translation of commands
Accepted parameters Translation
0000h to 03FFh Translates within a rage of 08D0h to 5700h
D30/31 Mode
Focus position
Cameras Parameters
EVI-D30/D31 1000h (FAR) to 9FFFh (NEAR, 1 cm)
EVI-D100/P 1000h (FAR) to 8400h (NEAR, 10 cm)
Translation of commands
Accepted parameters Translation
Values less than 8400h Accepts as is
Values greater than 8400h Translates to 8400h
The actual focus position does not match the value that
is defined by the D30/D31’s parameters.
Translation when answering inquiry
commands
Parameters Translation
1000h to 8400h Sends back parameters as is
During the period from the instant the camera accepts
the CAM_Focus Direct command at a value grater
than 8400h to the instant the camera accepts another
command to define the focus position, it sends back
the current D30/D31 parameters.
7000 0
3FF
Tele Wide
5700
0
8D0
370
4000
D30/D31
D100/P
Tele end Wide end Digital 4 Ч