Vaddio WallVIEW 100 Technical - Manual (Page 5)

5
Locations of Controls
Locations of Controls
Main Unit
3
4
1
2
5 8
9
q; 6
7 qa
1 POWER lamp
2 STANDBY lamp
3 Lens
4 Sensor for the remote
commander
5 BACKUP switch
6 VIDEO jack
7 S VIDEO jack
8 IR SELECT switch
9 DC IN 12 V jack
0 VISCA OUT jack
qa VISCA IN jack
qs IR SELECT switch
Set this switch to ON to allow the
camera output signals transmitted
from the Remote Commander to
the Color Video Camera via the
VISCA OUT jack to be output.
When you don’t intend to do so,
set it to OFF.
qd D30/D31 mode switch
Set this switch to ON to enable
you to operate the Color Video
Camera using the VISCA
commands for the EVI-D30/D31.
When you don’t intend to do so,
set it to OFF.
Note
You cannot use some of the
commands of the EVI-D30/D31
even if you set this switch to ON.
qf Tripod hole
qf
2 1
ON
qd qs
Front
Rear
Bottom