Vaddio REVEAL - Manual (Page 10)

REVEAL IN-Wall Cameras
REVEAL IN-Wall Camera Manual Document Number 342-0059 Rev. A Page 10 of 28
Step 11:
After the connections are made in Step 10, attach the Front Face Cover over the ¼’-20 posts and carefully tuck the extra
wires length of the IR/LED and Smart Glass leads along the side of the circuit boards and behind the vertical cover fins of
the face frame.
Step 12:
Attach the four (4) ¾” OD x ¾” tall, brushed aluminum stand-offs over the ¼”-20 posts and tighten snuggly by hand.
Screw in the four (4) ¼” x 20 x 1.0” threaded posts into the ¾” brushed aluminum stand-offs with the Allen (hex) wrench
receptacle facing out. Slip the four (4) ¾” OD thin (clear) nylon washers over the threaded posts. The connector for the
Smart Glass is on the circuit board inside the race track shaped front bezel housing on the right hand side of the face
frame cover. See page 11 for rotary and dip switch settings and set the switches to the desired position now.
Step 13: For Smart Glass Only
From the back of the Smart Glass, there are two
(2) wires that terminate on a black 2-wire
connector. This cable is connected to the Smart
Glass PCB connector.
NOTE: Skip this step when using the Clear
Glass model (since there are no wires on the
clear glass).
Remove the
fingerprints on the
frame cover on this
step or the next step
¼”-20 Posts
X 4
¼”-20 x 1”
Posts X 4
(Allen fitting
facing out)
¾” OD x ¾” tall,
brushed aluminum
stand-offs X 4
¾” OD thin
(clear) nylon
washers X 4
Smart Glass
PCB Connector
Smart Glass
2-Wire Connector
(from back of
Smart Glass pane)