Avaya 9101 - Manual (Page 11)

3
The TOP VIEW includes the following:.
1) LINE jack (on top side of telephone)
This jack, located on the top/rear of the set, is used to connect the
telephone and the modular wall jack. Use the 7-foot cord that comes
with the set.
2) Ringer indicator/Message light
This indicator flashes when the telephone rings with an incoming call.
The light also flashes when you have a message.
3) Dial pad
The standard dial pad can be used for normal dialing.
4) FLASH button
This button is used with PBX systems to activate special PBX facilities
such as Hold or Transfer which may be available in your PBX.
Note: If you press the switchhook on your telephone rather than the
Flash button, the line and the call will be released automatically. After
a minimum of two seconds, you will hear dial tone and you may begin
dialing.
5) Handset cord jack
This jack, located on the left side of the set, is used for connecting the
handset with the telephone.
6) Handset
The handset is used for placing and receiving calls.