Westwood Design Waverly Convertible Crib (WA-CR-9611NR) - Manual (Page 6)

Required Hardware
8 x Barrel Nut (I)
8 x Allen Bolt, 3-1/8” Long (J)
Allen Wrench (R)
Crib Side (D)
Allen Bolt (J)
Barrel Nut (I)
Crib Side (E)
Step 1
A. Position the stabilizer bars so that the four large holes face the inside of the
crib. The two smaller holes for the spring deck should be at the top.
B. Place a barrel nut (I) in the hole, with the slot aligned horizontally.
C. Put the allen bolt (J) through the crib side and thread it into the barrel nut.
D. Use the allen wrench to securely tighten the bolt.
E. Repeat with the remaining 7 holes.
Stabilizer Bar (H)
Spring deck mounting holes should be
toward the top